Reverse osmosis system Merlin
Osmoseur à débit direct
Specifications
This unit is quiet and economical. It's simple to install under your sink and comes with all hardware required for installation.
Performance can vary depending on the quality of the water inlet.
Typical Performance:
- RO water flow: 1.5 to 3 l / min
- Rejection rate: 95%
| Minimum | Maximum | |
| RO water flow | 1.90 l/min | 3.78 l/min |
| Rejection rate | 90% | 99% |
| Concentrate flow | 3.8 l/min | 7.6 l/min |
Dimensions
- Height: 26.82 cm
- Length: 50.89 cm
- Depth: 24.25 cm
NB: Dimensions are in mm and those in brackets in inches.
Terms of Use
| Minimum | Maximum | |
| Supply Pressure (1) | 2.76 bars | 5.52 bars |
| Water temperature | 4°C | 38°C |
| Dissolved solids (total mineralization of water) (2) | 50 mg/l | 2000 mg/l |
| Water hardness (3) | - | 17 °dF |
| Free chlorine (4) | - | 1.0 mg/l |
| Dissolved iron (5) | - | 0.3 mg/l |
| Manganese (5) | - | 0.1 mg/l |
Notes:
(1): Usually Swiss homes are equipped with pressure regulators adjusted to 4 bar.
(2): Switzerland Drinking water contains between 150 and 350 mg / l of dissolved solids and there is no drinking water with more than 1000 mg / l of dissolved solids (WHO recommendations: max. 500 mg / l). If you have any doubt, send us or bring us a sample of your water to a free control of the concentration of dissolved solids.
(3) If your water has a hardness greater than 17 ° dF, there must be a water softener or a electronic anti-scale system (up to about 25 ° dF) before the reverse osmosis unit. Contact us for a special offer.
(4): In Switzerland the concentration of chlorine in drinking water is generally less than 0.2 mg / l
(5): Normally drinking water contains no or very little dissolved iron and manganese. If your water should be an exception, contact us for an offer.
Installation
The installation should be done by your plumber of trust.
Typical installation time: 1 to 2 hours.
Options
- Conductivity online
- It lets you view the quality of the water produced.
- UV option
- A double barrier against bacteria.
Consumables
The membranes must be changed every few years. The filter cartridge should be replaced once every six months.
- Pack of 2 high-speed membranes
- Cartridge pre-filtration
- Post filter
